![]() Having this number higher will get lower printing times, but increase oozing and stringing. The preset number in PrusaSlicer is 1 mm, which is a low amount. Minimum travel after retraction: Amount of move that will trigger a retraction (mm).A higher value improves stringing, but if it is too high it may skip steps in the motor. Retraction Speed: Extruder motor speed on retraction.Note that disabling this feature may cause the nozzle to hit the printed part. Having this setting lower will improve stringing. Lift z: lifts the extruder during movement.On the MK2.5/S and MK3/S/+, the retraction length should be a maximum of 2 mm.ĭue to the Bowden extruder, the retraction length of the Original Prusa MINI/MINI+ presets are much longer (default 3.2 mm). ![]() Retraction length: Amount that the filament is pulled back when a retraction is triggered. ![]() Flexible materials are a special case and can need a lot of tweaking and tuning. Retraction settings can be found in PrusaSlicer in Printer Settings -> Extruder 1.įlexible filaments usually need longer retractions, because the material stretches while being pulled back to the nozzle. Once the extruder moves to the next location the printing process continues – the filament is pushed back out and it starts extruding from the nozzle again. What does retraction do? When the extruder has finished printing one section/object of your g-code, the filament is pulled back into the nozzle. You should start by checking a parameter known as Retraction. However, if you are printing with your own settings, make sure that you have the retraction settings configured correctly. We highly recommend using our official (factory default) preset settings in PrusaSlicer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |